In a well-ventilated area, lay the wooden letters/wooden words on a drop cloth or newspaper. Before starting to spray paint, read the safety and application instructions on the can.
Step 2
Spray paint the letters with Krylon® COLORmaxx™ in Gloss Ivy Leaf. Allow the wooden letters/wooden words to dry fully, usually ready to handle in 1 hour after application.
Step 3
Lay the burlap fabric on a flat surface.
Step 4
Loosen the embroidery hoop and remove the inner hoop.
Step 5
Place outer hoop under the burlap and the inner hoop on top. Push the inner hoop into the outer hoop with the burlap in between.
Step 6
Pull burlap as tight as possible and tighten the hoop.
Step 7
Trim excess fabric around the hoop leaving a few inches. Save the scraps, which will later be used to create the hanger.
Step 8
Take the needle and thread and sew the ribbon ruffling it around the edges of the burlap.
Step 9
Once the spray-painted letters/words are completely dry, use a hot glue gun to glue the wooden letters onto the burlap. If your door is in the direct sunlight use another permanent/ultra-strong glue in place of a hot glue.
Step 10
Take the remaining 2 spools of ribbon and make a bow. Tie the center of the bow with scraps of ribbon.
Step 11
Take the excess burlap and cut a strip that is 3-4 inches wide and about 3 feet long.
Step 12
Loop the burlap under the screw at the top of the hoop to create a hanger.
Step 13
Attach the bow to the hoop by tying it to the screw.
WOOD INSPIRATION
Get Inspired To Spray
Wood and spray paint are a great combo. Go big and revive a piece of furniture. Go small and revamp a decorative box.